Cutting Machine-620 Operation Manual For Plate Separator

 

We mainly sales FPC punching cutting machine, LED cutting machine, PCB circuit board cutting machine, aluminum board cutting machine, lamp strip cutting machine, circuit board cutting machine, pneumatic type cutting machine, feeding mode machine, automatic curve V-CUT, PCB/FPC punching mould and so on, which are mainly used in mobile phone, household appliances, lighting and a variety of soft and hard PCB board in other related electronic industry, lamp, lamp belt, aluminum plate and other high-end electronic equipment. We aim at improving productivity, reducing costs and improving the quality of the products.

Product introduction

Adopting the latest gas-electric lightweight design , the machine can finish a cutting schedule without shear stress in one time, which is particularly applicable to the precision SMD or sheet. The bow waves and micro crack will be generated when not using circular knife. This machine employ the wedge tool to cut board linearly , so that the shear stress is minimized and the sensitive SMD components and even capacitors are not affected. In this way, the potential quality risk is dropped to minimum. This is n concerns on safety with a cutting schedule under 1-2 mm . The blade is made of high speed steel by precision grinding , it is reusable after grinding. And the machine applies to sheet without V-Cut.

Features

1. Cutting with the double straight knives , it is especially suitable for the segmentation of precision SMD sheet and aluminum PCB

2. With guillotine operation, it applies to PCB of all kinds of thickness , whose board schedule is less than 1-2 mm , so that there is no concerns about safety.

3. The inner stress when cutting will be under 180 UE , in case of a solder  crack and the damage of precision components .

4. The minimum width between the edge of V-groove and the parts is 0.3 mm , and the maximum height is 70 mm

5. We provide free grinding service of the blade after its abrasion.

6. The cutting rate is one segmentation for one second , controlled by pneumatic pedal switch.

7. The starting of the cutting set is for passive , so that the cutting tangent and position is under secure control. With little stress when cutting , there will no solder crack.

8. With cutting of non-roller (circular knife , straight knife) type , there is no dust , no motor drive , and no carbon powder pollution.

9.With non-rubbing type cutting , there is no metal residue.

10. The blade can be used 600000 times without power supply , avoiding the loss and change of electrical products.

11. The machine uses 0.5-0.7 MPA air compressor without specific cutting place , and it is maintained by wiping its appearance with the anti-rust oil.